Komatsu Part SEAL 07012-60100

—

Product Overview

The 07012-60100 SEAL is a genuine Komatsu OEM replacement seal. Seals are the barrier components that keep your machine's hydraulic oil, engine oil, gear oil, and coolant contained within their respective systems while blocking dirt, water, and debris from entering. This seal is designed for a specific shaft, bore, or housing interface in your Komatsu equipment — it uses a flexible lip that maintains contact with the rotating or sliding surface, held in place by a garter spring that compensates for gradual lip wear over thousands of operating hours.

Part Number: 07012-60100 Part Name: SEAL Part Type: OEM Komatsu Replacement Seal Availability: In stock — ready to ship

—

The Progressive Damage of a Leaking Seal

When a seal first begins to leak, the symptom is barely noticeable — a slight film of oil on the shaft or a damp area around the seal housing. At this stage, many operators and even some service technicians will wipe it off and plan to monitor it. This is a mistake. The seal has already lost its ability to maintain a consistent barrier. The leak path, however small, allows contaminants to enter the system — dirt and moisture that circulate with the oil and accelerate wear on pumps, bearings, valves, and other precision components. Meanwhile, the seal lip continues to harden from heat exposure and wear from contamination, and the leak worsens. The fluid loss also increases, requiring more frequent top-ups — and if the leak is on a suction line, the seal can draw air into the hydraulic system, causing pump cavitation that destroys the pump internally. The seal that could have been replaced during a scheduled maintenance window for a modest cost becomes an emergency repair that stops production. For Komatsu equipment owners and fleet managers, addressing seal leaks at the earliest possible stage is consistently the most cost-effective strategy.

—

When to Replace

Replace the 07012-60100 when oil is visible on the shaft or housing near the seal; when the seal lip is hardened, cracked, or the garter spring has broken or come off; when a wear groove has developed on the shaft at the seal contact point; or whenever the component is disassembled for any service.

—

Installation

1. Confirm 07012-60100 in your Komatsu parts catalog
2. Inspect the shaft surface where the seal rides — grooves, scoring, or corrosion will damage the new seal
3. Clean the seal bore in the housing — old seal remnants and debris prevent proper seating
4. Lubricate the seal lip with clean system fluid — never install dry
5. Press to the correct depth using a seal driver with the proper pilot diameter
6. Check for leaks during initial operation and after reaching normal operating temperature

—

Request a Quote

Need the Komatsu 07012-60100 SEAL? Contact us through the form on this page, or reach out by phone, email, or WhatsApp. We respond within one business day.