Komatsu Part BAND 08034-00414

—

Product Overview

The 08034-00414 BAND is a genuine Komatsu OEM replacement band from the 08034 prefix series. Bands are flexible, adjustable clamping devices that apply even pressure around the full circumference of hoses, tubes, wiring harnesses, rubber boots, convoluted tubing, and protective sheathing. Unlike rigid clamps that concentrate clamping force at a narrow contact point, bands distribute the load around the entire component, making them the preferred choice for securing flexible or thin-walled components that could be damaged by point loading.

Part Number: 08034-00414 Part Name: BAND Part Type: OEM Komatsu Replacement Component Availability: In stock

—

Where Bands Are Used

You'll find bands throughout your machine — securing dust boots on cylinder rods and linkage connections, clamping protective spiral wrap around hydraulic hose bundles, holding insulating blankets on exhaust components, securing wiring harness branches at critical junction points, and fastening flexible ducting in the HVAC and engine air intake systems. Each application places different demands on the band — heat resistance near exhaust components, corrosion resistance in undercarriage locations, clamping force for vibration-prone assemblies. The OEM band is specified for the exact environment where it will be installed, using the appropriate material — typically stainless steel for corrosion resistance or coated carbon steel for general applications.

Bands are consumable items by design. They're meant to be cut off and replaced when the component they secure is serviced — reusing an old band is unreliable because the locking mechanism loses its holding force after being released. Replace the 08034-00414 whenever the secured component is removed for service; when the band shows corrosion, especially at the buckle or locking tab; when the band has been overtightened and the body is deformed or cut; or when the band no longer holds the component securely against movement.

—

Installation

1. Confirm 08034-00414 in your Komatsu parts catalog — verify the correct diameter and material for the application
2. Position the component that the band will secure — make sure it's correctly routed and aligned before applying the band
3. Wrap the band around the component and thread the tail through the buckle or locking mechanism
4. Tension the band using a banding tool or pliers — tighten until the component is held firmly without crushing
5. Trim the excess tail close to the buckle — leave enough to grip if future removal is needed, but not so much that it creates a snagging hazard
6. Verify the component cannot slide or rotate within the band under moderate hand force

—

Request a Quote

Need the Komatsu 08034-00414 BAND? Contact us through the form or by phone, email, or WhatsApp. We respond within one business day.